Saturday, 23 January 2021

3D Print connector for Spike and inovator

DIY connector for Lego spike and inventor

Step 1:Print plug

Thingverse link

Step 2: Use 0.6 mm single wire and push them through the holes.
Step 3: hot glue wires from the  back, so they stay in place

Step 4: you can add some instant glue below wires if you wish, but that's not 100% necessary.

Step 5: Then cut wires. In real plug ground should be longer than others.

See more info about connector at HERE

No comments:

Post a Comment